(954) 718-3094 Request an estimate

Miami-Dade County, Florida

Concrete Restoration in Bal Harbour

Careful, well-planned repair work for the oceanfront towers of Bal Harbour, from balcony stacks and garages to pool decks, roofs and facades.

In short

Who repairs concrete in Bal Harbour?

Concrete restoration in Bal Harbour is carried out by a licensed contractor working from repair documents prepared by the owner's engineer or architect. SERPE-CO is a Certified General Contractor that repairs balconies, columns, podium garages, pool decks and facades on the village's oceanfront condominium towers, removing damaged concrete, treating the steel, rebuilding and waterproofing each location under a village permit.

Free milestone planner

Is a milestone inspection coming due on your building?

Enter the year your building got its certificate of occupancy and how many stories it has. The planner estimates your deadline under Florida law, then you can send it to SERPE-CO for a second look.

Building type

Add the year and story count for an estimated due date.

About this estimate

This is a planning estimate drawn from the statewide rule in Florida Statute 553.899. Your local building department sets the real deadline and may call for the first inspection at 25 years instead. Broward County also has its own Building Safety Inspection Program. Check your date with your building official and engineer, or contact SERPE-CO and we will help you sort it out.

Bal Harbour

Boards looking for concrete restoration in Bal Harbour usually manage a tower on the ocean side of Collins Avenue, where salt, wind and age have reached the balconies, the garage or the pool deck. SERPE-CO is a family-owned contractor from Pompano Beach, run by brothers Brett and Jason Serpe, with more than 20 years in the field. We plan the work around residents who expect a quiet, orderly building, and we follow the drawings written by the association's engineer from the first chip to the final coat.

Bal Harbour is a small village at the north end of the barrier island, with Haulover Inlet on one side and Surfside on the other. The oceanfront is lined with condominium towers, and a residential section of single-family homes sits west of Collins Avenue along the waterway. In a place this compact, every repair project is visible to the whole community, so planning, protection and communication matter as much as the concrete work itself.

Brett Serpe, MBA, GC, CEO of SERPE-CO

Reviewed by Brett Serpe, MBA, GC, CEO of SERPE-CO · Florida Certified General Contractor CGC #1523974

Prepared by the SERPE-CO project team, with more than 20 years in concrete restoration. Last reviewed November 2026.

Concrete Restoration in Bal Harbour by SERPE-CO

Summary

Bal Harbour: quick facts

  • 01

    Bal Harbour is a village at the north end of the barrier island, between Haulover Inlet and Surfside.

  • 02

    Most of Bal Harbour's condominium towers stand on the ocean side of Collins Avenue, with podium parking and raised pool decks.

  • 03

    The Bal Harbour building official enforces recertification under Section 8-11(f) of the Code of Miami-Dade County.

  • 04

    Bal Harbour is in the High-Velocity Hurricane Zone, where windows, doors and roofing need a product approval such as a Miami-Dade Notice of Acceptance.

  • 05

    SERPE-CO carries out repairs only; the owner's licensed engineer or architect performs inspections and writes the repair documents.

Local building stock

The buildings of Bal Harbour

Almost all of Bal Harbour's multi-story concrete stands on the east side of Collins Avenue, facing the beach. The towers vary in age, from buildings put up in the 1960s and 1970s to much newer high-rises with glass facades. Most have parking in a podium or below a raised deck, with a pool, cabanas and landscaped terraces above, and a driveway and porte-cochere facing the avenue.

West of Collins Avenue, the village's residential section is made up of single-family homes on streets that reach the waterway. Those homes are outside the scope of the county recertification program, but the area also contains seawalls, docks, clubhouse buildings and private amenities that use reinforced concrete. Commercial property in the village is concentrated near the south end, close to 96th Street and the Surfside line.

At the north end, the village meets Haulover Inlet, where tidal currents move between the ocean and Biscayne Bay. Buildings near the inlet take wind and salt from more than one direction. Across the whole village, lots are narrow and buildings sit close together, which limits staging space, crane positions and delivery routes and puts neighbors close to any work zone. We work out where the dumpster, the material lift and the crew parking will go before the first day, and we revisit that plan with management as each phase moves around the building.

Have a question about your building?Call the office or send a quick request. A real person answers.

Common failures and causes

What wears out first on Bal Harbour towers

Oceanfront exposure drives most of the concrete damage in Bal Harbour. Wind-driven spray coats the east and north faces of each tower, and chlorides move through the concrete to the reinforcing steel over the years. The first signs are usually rust stains at railing posts, cracks along balcony slab edges and loose concrete on soffits. In older towers with thin cover over the steel, those signs come back after each repair cycle unless the corroded areas are fully removed.

Podium garages and raised pool decks are the second weak point. A pool deck over a garage depends on its membrane, drains, planters and expansion joints to keep water out of the structure below. When any of these fails, water drips through the garage ceiling, rust spreads in the slab and the topping above starts to crack. Roof slabs under cooling towers and other equipment, and the parapets around them, are another common source of leaks. Driveways, porte-cocheres and entry canopies facing Collins Avenue round out the list, since they take daily traffic, rain and salt and are the first thing residents and guests see.

Services

Concrete Restoration in Bal Harbour: our scope of services

Balconies & Railings

Balcony stacks on the ocean face of a Bal Harbour tower usually carry the largest share of the repair scope. We remove finishes, repair slab edges, soffits and railing post pockets to the engineer's details, rebuild the slope, waterproof the deck and install new railings, one stack at a time from swing stages.

Commercial Pools & Decks

Raised pool decks over podium garages are a central feature of most towers in the village. We open the deck to the structural slab where the drawings require, repair the concrete, rebuild drains, joints and planters, and resurface the pool shell down to sound substrate before a plaster or quartz finish.

Parking Garages & Plaza Decks

Podium garages in Bal Harbour take water from the deck above and salt from cars coming in off the avenue. Repairs include slab soffits, beams, columns, joints and traffic coatings, phased with management so residents and valet operations keep working through each stage.

Commercial Roofing

Tower roofs carry cooling towers, elevator machine rooms and window-washing equipment, and leaks usually start at curbs and parapets. We repair roof slabs and reroof with systems carrying a Miami-Dade Notice of Acceptance, as the High-Velocity Hurricane Zone requires, to the roof consultant's specification.

Impact Windows & Doors

Many older towers are replacing original sliding doors and windows. Each opening is repaired before the new unit goes in, and the frames are anchored with stainless steel screws, each one bedded in urethane hybrid sealant, so no fastener sits bare against the concrete where it could rust. Units carry a Miami-Dade Notice of Acceptance, and every installation follows the anchoring that approval describes.

Stucco & Painting

A repaint is part of every oceanfront maintenance cycle, typically every 7 to 10 years. We repair stucco and concrete first, seal the joints, and apply the coating system, working with our paint supplier partners on color overlays of the tower so the board can see each scheme before it decides.

Browse all our work in Miami-Dade County, or view the complete list of our services.

Inspections and permits

Recertification and permits in Bal Harbour

The village building official enforces the county recertification program under Section 8-11(f) of the Code of Miami-Dade County within Bal Harbour. Buildings are recertified at 30 years and every 10 years after, and condominium and cooperative buildings three stories or taller within three miles of the coastline are recertified at 25 years. Oceanfront towers are plainly near the coast, but the building official confirms the cycle and the due date for each building.

For condo and co-op towers with three or more habitable floors, the state milestone inspection under Florida Statute 553.899 and the reserve study required by Florida Statute 718.112 apply as well. Miami-Dade combines the two milestone phases into a single inspection. Bal Harbour lies in the High-Velocity Hurricane Zone, so new windows, doors and roof systems need an approval such as a Miami-Dade Notice of Acceptance. A licensed engineer or architect performs every inspection. SERPE-CO is the repair contractor.

Around Bal Harbour

Neighborhoods and corridors we cover

  • Collins Avenue oceanfront
  • Haulover Inlet area
  • Bal Harbour residential section
  • 96th Street
  • Waterway frontage
Ready for a site visit?Tell us where the building is and what you are seeing. We will set up a time to walk it.

How we run a job

From the first site visit to a closed permit.

  1. 01

    Meet on site

    Each job starts on site, walking the property and its conditions with your manager, board or engineer.

  2. 02

    Follow the engineer's scope

    The engineer writes the scope. We price it line by line, plan access and lay out each phase to build it.

  3. 03

    Put safety first

    We can never work too safely: shoring, swing stages, barricades and notices go up first.

  4. 04

    Build the repairs

    Crews work through the repairs in order, stopping for inspections wherever the engineer calls for them.

  5. 05

    Finish and document

    Final inspections, a closed permit and a full record of the work for the association.

Questions

Questions we hear in Bal Harbour

Who performs structural repairs on oceanfront towers in Bal Harbour?

The repairs are performed by a licensed contractor to the documents of a licensed engineer or architect. SERPE-CO works as the contractor on balconies, garages, pool decks, roofs and facades, under a permit from the village. Residents stay in their homes, and the work is phased by stack and by area, with a written calendar issued to owners before each phase begins.

How is a Bal Harbour pool deck repaired without losing the whole summer?

The deck is usually divided into sections so part of the pool area stays open, or the work is timed for the months the board chooses. Structural repair, drainage and waterproofing come first, then the finish. The schedule depends on the scope in the engineer's drawings, and we lay it out with the board before work starts.

Why do concrete repairs on older Bal Harbour towers keep coming back?

When corroded steel is not fully exposed and treated, or when chloride-laden concrete is left at the edge of a patch, corrosion continues beside the repair. Concrete restoration in Bal Harbour has to remove that contaminated material, protect the steel and seal the surface, so the same location does not fail again a few years later.

Is the 25-year recertification cycle used for Bal Harbour condominiums?

Under the county code, condominium and cooperative buildings three stories or taller within three miles of the coastline are recertified at 25 years and every 10 years after. Oceanfront towers in Bal Harbour are close to the coast, but the building official confirms the cycle and the due date for each property.

How does SERPE-CO protect the beach and neighboring buildings during facade work?

Debris is captured at each swing stage with netting and enclosures, and walkways below are covered. Beach access is kept clear of the work zone, and wash water and slurry are collected instead of running off. On narrow lots, staging and deliveries are agreed with management and, where needed, with the neighboring building.

Laws and rules cited

Treat this page as general information only, not legal or engineering advice. Licensed engineers and architects perform the inspections, and the building official decides which dates apply to your property. SERPE-CO's role is to carry out the repairs.

Working with an engineer?

Holding drawings, specifications or a complete set of bid documents?

Structural engineers, property engineers and board members send SERPE-CO much of our restoration, pool and roofing work. Once a scope has been drawn and specified, our team prices what the documents show, raises questions where something is unclear, and lays out each line so boards can weigh the bids on equal terms.

Request an estimate

Let's plan your restoration.

Tell us where the building is and what you are seeing. We set up a visit to the property, then send a written proposal, or tell you an engineer needs to write the scope first.

  • More than 20 years in the field
  • St. Lucie, Martin, Palm Beach, Broward and Miami-Dade
  • Family-owned Certified General Contractor

Rather call?(954) 718-3094

Work needed (choose all that apply)
Call Request an estimate